All you need to run your factory !
Use:
For holding inserted tooth milling cutters and cutters with driving slot DIN 1880 and exceeding clamping diameter 40 clamping according to DIN 2079 is possible, too (4 additional tapping holes)
Coolant exit bores on the end face for milling cutters with central cooling similar to DIN 6357 with taper
similar to DIN 6357 with taper
Form ADB means: central coolant supply and coolant channels through the flange which can be sealed again
– Included in delivery: tightening bolt, size 16.1 with reduced contact diameter
1) Also suitable for ANSI-CAT
INTERNET USERS ALSO CONSULTED ON THE CATEGORY ACCESSORIES
See also
