All you need to run your factory !
Gear motor with worm screw and standard motor Ø 42 30 output W 12/24 Vdc 3700 RPM loadness, with electric noise
suppressor. Driving shaft mounted on a bearing and bushing. Outlet shaft supported by two bearings with oil splash
guard on the outlet side.
* The rotation speed can change of ± 10%.
Connecting 2 wire 0,75 x 250 mm.
The S1 load test was made using a 1,6 A corrent in the air with an increase of temperature of 70 C°
The S2 load test was made using a 3,0 A corrent in the air with a timing 5` ON 5` OFF with an increase of temperature
of 80 C° max
The starting corrent is 5 A and cannot be maintained for more than 2
Max forces wich may act on the outlet shaft: Axial 25 kg, Radial 40 kg
It is possible to apply encoder
INTERNET USERS ALSO CONSULTED ON THE CATEGORY HYDRAULIC MOTORS
See also
