All you need to run your factory !
Gear motor with worm screw and standard motor Ø 37x34 12/24 Vdc 5000 RPM output W, with noise suppressor.
Driving shaft mounted on two bearing and bushing. Outlet shaft supported by two bearings.
Design to give low RPM in little dimension
* The rotation speed can change of ± 10%.
The S1 load test was made using a 0,8 A corrent in the air with an increase of temperature of 70 C°
The S2 load test was made using a 1,5 A corrent in the air with a timing 5` ON 5` OFF with an increase of temperature
of 80 C° max
The starting corrent is 5.4 A and cannot be maintained for more than 2
Max forces wich may act on the outlet shaft: Axial 25 kg, Radial 40 kg
It is possible to apply an encoder.
INTERNET USERS ALSO CONSULTED ON THE CATEGORY HYDRAULIC MOTORS
See also
