Watco Concrete Sealer Water Based seals and hardens new and old bare, porous concrete floors and screeds. It is micro-porous which allows the surface to breathe.
Watco Concrete Sealer Water Based contains a micronised acrylic which penetrates deep into porous surfaces to bind, harden and seal. The cross linking properties of the acrylic dries to form a surface film, providing a more stain resistant, easier to clean finish. The appearance can vary from low sheen to gloss depending upon the porosity of the substrate and the number of coats applied. It is quick and easy to apply and most suited for use in warehouses and production areas, or anywhere which would benefit from a penetrative, dustproof, virtually odourless sealer for medium trafficked areas.
Concrete Sealer Water Based is also available in a light grey finish, which both seals and tints the floor at the same time. Concrete Sealer Water Based is breathable, virtually solvent free and safe for use in confined areas. It has an A+ VOC emissions rating with a very low VOC content.
Recommended areas of use
-
Warehouses
-
Production Areas
-
Garages
-
Storage rooms
Features of Concrete Sealer Water Based
-
Clear, acrylic, water based sealer
-
Also available in a light grey tinted version to both seal and add colour
-
Penetrates, dustproofs and hardens in just one coat
-
Single pack sealer – easy to apply
-
Ready for full use after 24 hours
-
Only one coat is generally needed saving on downtime
-
Minimal darkening effect on most surfaces
-
Breathable
-
Virtually solvent free and low odour
-
Glossy finish – stain resistant and easy to keep clean
All you need to run your factory !
