Perfect interaction :
The perfect balance of a modern touchscreen controller and smart software provides the operator full control over their saw. The touchscreen controller is at eye level and provides all necessary information needed by the operator. The height and angle of the saw blade can be positioned within a few seconds. Like the other T60 series saws, the Classic also provides step-by-step menus to prompt the operator through complex joinery and angular cuts.
High-quality mechanical design :
The T60 is supported by a solid, heavy 6mm thick plate steel frame. The sliding table is designed like you would expect a MARTIN machine should be: with a replaceable table lip and a beefy, highly-ribbed, hollow-chambered aluminium profile.
Controlled rip fence adjustment :
The rip fence of the T60 Classic runs on pre-cison ball bearings and is adjusted effortlessly from the operator position via a hand wheel. The cutting-width display, which is integrated in the touchscreen controller, allows you to quickly adjust measurements down to a tenth of a millimeter. Even if you rotate the aluminium fence extrusion for veneer overhang applica- tions, the measurement will be correct, thanks to the intuitive touchscreen. As an option, the T60 can be ordered with a motorized rip fence that is fully integrated in the controller, turning the T60 Classic into a 3 axis cutting machine.
Comfortable angular cutting :
Every T60 is designed to fully support angular cuts. Detents for commonly used angles and length compensation software in the touchscreen controller make for precise angular cuts when using the cross-cut fence. The optional miter cross-cut table can make your T60 a full-fledged miter-cutting center.
All you need to run your factory !
