Semi-Automatic Flexografic Printing Press 3 colours – 150 mm. width

Load the material (inks - cliché - tape - carton cores)
Set up and monitor the printing stations and feeding ink when needed
Set up the slitting station
At the end of the desired printing length cut the material, discharge the printed rolls and load the empty cores on which will be attached the material to continue printing operation
380 Volts - 50 Hz - 3-Phase (other voltages on request)
Cast Iron Support Frame
Safety Guards all over the machine except the rewinding shafts.
When safety doors are opened the L36 stops and it can run pushing Start bottom at impulses.

3 i.d. frictioned un-winder for PP tape
Noise reducer & Low Tape alarm pressure roller
External Module for Corona Treatment unit
Corona Treatment proportionally adjusted on tape speed
Ventilation & Suction system for Corona Treatment
Primer Station before printing for tape printing preparing
Ventilation & Suction system for Primer Station
Pressure roller for Primer station
Hot/Cold Air drying tunnel after Primer Station
3 Printing Stations complete with metal screened rollers and printing cylinders with gears for 150,7 mm print repeat
Adjustable bracers for each printing station
Thermo-adjustable Teflon covered central drum
Ventilation & Suction tunnel for colours drying
Release Station after printing for tape printing securing
Ventilation & Suction system for Release Station
Pressure roller for Release Station
Hot/Cold air drying tunnel after Release Station
Air Blower for tape cooling before slitting
Slitting Station with razor blades from the adhesive side
Twin turrets re-winders with 2 mandrels for 3 i.d. cores
Once reached the pre-selected length the machine slows the speed down and after a pre-set time they rotate and the machine gradually reaches the selected speed.

Free Un-winder 3 i.d. for PVC tape
Pneumatic pump for automatic Primer and Release feeding
Accessories standard included

9 additional different cliché cylinders with gears
3 x Z60 = 188,4 mm printing repeat length
3 x Z80 = 251,2 mm
3 x Z100 = 314 mm „ „ „
other sizes replacing the above mentioned on request
Cliché mounting device
Set of spacers for slitting blade holders setting
152 mm rubber roller for fload coating
50 mm. paper tab dispenser + 30.000 paper tabs
Set of spare parts
The Training is included in the sales conditions before the machine shipment.

This is essential to understand the machine usage and maintenance and optimize its productivity; it's also required to completely set up the machine according to the materials (tapes - inks - solvents) that you would like to use.