CleanAir Heated In-Line Filter Pump Assembly | In-Line Heated Filter Pump

CleanAir Heated In-Line Filter Pump Assembly | In-Line Heated Filter Pump - CLEANAIR ENGINEERING EUROPE

CleanAir Heated In-Line Filter Pump Assembly | In-Line Heated Filter Pump - Air analysis

CleanAir Heated In-Line Filter Pump Assembly | In-Line Heated Filter Pump - produit présenté par CLEANAIR ENGINEERING EUROPE

CleanAir Heated In-Line Filter Pump Assembly | In-Line Heated Filter Pump

Air analysis

Ask for a quote

Presentation

The Clean Air Engineering CEM Heated In-Line Filter and Pump is intended for emissions testing and chemical analysis. It is important to maintain a constant temperature around 120 ° C to ensure that moisture, sour gas and other constituents of the gas stream do not condense before entering the analysis equipment. This can lead to hardware damage as well as loss of important data. The heated in-line filter and pump assembly helps ensure the accuracy of gas samples by providing a heated path for the gas prior to analysis. The filter, stainless steel needle valve and pump are insulated and heated. This unit includes a dual heater controller. All components are modular and therefore easy to maintain. This device is also small and light, which makes it easy to carry. For use in: process monitoring, stack testing, EMC, gas and diesel sampling.

The heated in-line filter holder with a heated ADI sample pump for sample gas distribution. This combination can be used with an extractive FTIR system or other hot CEMS to provide hot sample flow without particles for your measurement system.

Heated In-Line Filtration Pump Specifications:
Weight: 18Kg
Dimensions: 31 x 43 x 54 (L x W x H) cm
Maximum pump flow: 27 l / min
Pump amperage: 3.6-4.0 amps
Pump heater amperage: 1.25 amps
Pump power: 120/240 volts, 60/50 Hz
Pump heat output: 2 @ 75 watts with type K thermocouple
Pump: Single head 316SS with Teflon ® membrane
Maximum pump heating temperature: 205 ° C
Filter heater power: 338.82 watts
Filter heater amperage: 2.82 amps
Maximum filter heater temperature: 205 ° C
Voltage requirements: 120 VAC
Model Filter size: 2.54cm x 17.78cm
Inlet and outlet fittings: 3/8 "stainless steel compression fitting